Check pricing
EN
heat pressing a DTF transfer onto a garment
RolaDruku›DTF guides›Heat pressing DTF

How to heat press a DTF transfer

DTF application depends on the right temperature, time and pressure. The values below are a safe starting point for standard application. If your order includes different instructions, always follow the parameters supplied with that batch.

Starting parameters for DTF application

Temperature150–160°C

a practical starting range for standard application

Time10–15 s

for the first press

PressureMedium–firm

even pressure across the entire transfer

Final press5–10 s

after removing the film, through protective paper

Application step by step

Prepare the garment

Lay the garment flat on the press and pre-press briefly to remove moisture and creases.

Position the transfer

Place the artwork in the required position with the carrier film facing upwards.

Press the transfer

Set the press to 150–160°C and press for 10–15 seconds using even, medium-to-firm pressure.

Remove the film

The correct peel method can depend on the transfer film used. Follow the instructions supplied with your order.

Final press

After removing the film, cover the print with protective paper and press again for approximately 5–10 seconds.

Washing after application

Wait at least 24 hours before the first wash. Wash the garment inside out, preferably at up to 30°C. Avoid bleach and do not iron directly over the print.

Always run a test first

Temperature and pressing time may need adjustment depending on the fabric, heat press and transfer batch. When working with a new substrate or a large production run, carry out a test before processing the full job.

Need DTF transfers by the metre?

View pricing